Tripp-lite PDU Rackmount Power Strips User Manual download pdf

PDU Rackmount

Power Strips

Designed for Mounting in 19 in. Racks

IMPORTANT SAFETY INSTRUCTIONS. This manual contains information concerning the proper

installation and use of Tripp Lite’s PDU Rackmount Power Strips. SAVE THESE INSTRUCTIONS.

Do not connect your power strip to an ungrounded outlet. Do not use it with extension cords or

adapters that eliminate its connection to ground. Your power strip is designed for indoor use only.

Install it away from heat emitting devices such as radiators and heat registers. Do not install where

excessive moisture or other conductive contaminants are present. Never install electrical wiring during

a lightning storm.

The power requirement of each device connected to an outlet of your power strip must not exceed the Outlet Power

Rating of your power strip. The total power requirements of all devices connected to your power strip must not exceed

the Maximum Load Rating of your power strip.

1U Rackmount Installation

To Mount Unit in Rack: Put four user-supplied rackmount screws (A) through the unit’s

mounting ears (B) and into the rack rails as shown. The user must determine the fitness of the

rackmount screws to hold the unit in the rack before installation.

0U Rackmount Installation

1. Reorient Mounting Ears: Unscrew the screws (A) holding the unit’s mounting ears (B) to

the sides of the unit. Use the screws from Step 1 (A) to reattach the mounting ears (B) to the

unit as shown. Use only the manufacturer-supplied screws or their equivalent (#6-32, ¼" flat

head) to reattach the mounting ears.

2. Mount Unit on Outside of Rack Rails: Put four user-supplied screws (C) or similar mounting

hardware through the unit’s mounting ears (B) and into the side of the rack as shown. The

user must determine the fitness of the user-supplied mounting hardware to support the unit

before mounting.

Wallmount/Under Counter Installation

Reorient the unit’s mounting ears as per the 0U Rackmount Installation above, then put four

user-supplied screws or similar mounting hardware through the unit’s mounting ears and into the

mounting surface. The user must determine the fitness of the user-supplied mounting hardware

to support the unit before mounting.

1U Rackmount Installation

0U Rackmount Installation

Owner’s Manual

Features

Circuit Breaker(s)

If the current draw of the equipment connected to

your power strip exceeds your model’s Maximum

Load Rating for longer than a few seconds, a cir-

cuit breaker will trip to prevent any possible dam-

age. When a circuit breaker trips, its plunger will

pop up. Remove excess equipment and allow the

breaker to cool one minute before depressing its

plunger to reset the breaker. Caution (PDU2430

model only): If you depress the circuit breaker

plunger during normal operation of your PDU,

power will be interrupted to the receptacles and

connected equipment will not be protected.

Grounding Lug

Use this screw (located by the power strip’s receptacles)

to connect your power strip to ground.

Input Receptacle (PDU12IEC Model Only)

The PDU12IEC has no power cord. Instead, it has

an IEC C20 input receptacle. To connect a

PDU12IEC to utility power, use a user-supplied

detachable power cord with an IEC plug on one

end and a plug appropriate to your local utility outlets

on the other.

Installation

Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and workmanship for its lifetime. If the product should prove defective in

material or workmanship within that period, Seller will repair or replace the product, in its sole discretion. Service under this Warranty can only be obtained by your delivering or shipping the product

(with all shipping or delivery charges prepaid) to: Tripp Lite, 1111 W. 35th Street, Chicago, IL 60609. Seller will pay return shipping charges. Call Tripp Lite at (773) 869-1234 before sending any equip-

ment back for repair.

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES

OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN. EXCEPT TO THE EXTEND PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES

OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND

CONSEQUENTIAL DAMAGES. (Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential

damages, so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights, and you may have other rights which vary from jurisdiction to jurisdiction).

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the use intended. Since individual applications are subject to great vari-

ation, the manufacturer makes no representation or warranty as to the suitability or fitness of these devices for any specific application.

Policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.

Limited Lifetime Warranty

www.tripplite.com/warranty

Regulatory Compliance Identification Numbers

For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number.

The series number can be found on the product nameplate label, along with all required approval markings and information. When requesting

compliance information for this product, always refer to the series number. The series number should not be confused with the marking name

or model number of the product.

200407059 93-2263 PDU Owner’s Manual.qxd 8/3/2004 2:18 PM Page 1

1 2 3

Summary of Contents

Page 1 - Owner’s Manual

PDU Rackmount Power Strips Designed for Mounting in 19 in. RacksIMPORTANT SAFETY INSTRUCTIONS. This manual contains information concerning the properi

Page 2 - Manuel de l'utilisateur

1111 W. 35th Street Chicago, IL 60609 EE UU • Atención al cliente: +1 (773) 869-1234 • 1111 W. 35th Street, Chicago, IL 60609 USA • Assistance Techn

Page 3 - 200407059 93-2263_FR

1111 W. 35th Street, Chicago, IL 60609 USA 773.869.1234 (USA) • 773.869.1212 (International) www.tripplite.com200407059 93-2263_FR

Comments to this Manuals

No comments

Tripp-lite PDU Rackmount Power Strips User Manual

Browse online or download User Manual for Computer Accessories Tripp-lite PDU Rackmount Power Strips. Tripp Lite PDU Rackmount Power Strips User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Computer Accessories Tripp-lite PDU Rackmount Power Strips