Owner’s Manual1111 W. 35th Street Chicago, IL 60609 USACustomer Support: (773) 869-1234 • www.tripplite.comImportant Safety Instructions2Installatio
The UPS’s control panel lights will turn on in the sequences below to signal that the UPS is havingoperational difficulties.Lights (On/Flashing) and C
11Troubleshooting (continued)Lights (On/Flashing) and Condition SolutionOn: FAULT, 25% Restart the UPS. If the problem persists,Flashing: LINE contact
Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product. You'll be automatically entered into adrawing fo
UPS Location Warnings• Install your UPS indoors, away from excess moisture or heat, conductive contaminants, dust ordirect sunlight.• For best perform
Mount your equipment in either a 4-post or 2-post rack or rack enclosure. The user must determine thefitness of hardware and procedures before mountin
Important Safety InstructionsConnection and Start-UpPlug your UPS’s line cord into anelectrical outlet.Your UPS must be connected to a dedicated circu
5Optional Connections (continued)USB and RS-232 SerialCommunicationsUse the included USB cable (see ) and/or DB9serial cable (see ) to connect the U
Front Panel Switches“ON/TEST” Button: This switch controls four separate UPS functions:UPS Power ONTo turn the UPS on, press this button, hold it for
7Front Panel Indicator Lights continued“BYPASS” LED: This yellow light will flash to indicate that the UPS’sDC/AC inverter is deactivated and the UPS
Rear Panel “REPLACE BATT” LED: This red light will illuminate constantly and theUPS alarm will beep every 2 seconds if your UPS’s microprocessor detec
9Rear Panel continuedAC Receptacles (Varied by Model): These 15-, 20- and 30-amp receptaclesprovide your connected equipment with pure sine-wave AC ou
Comments to this Manuals