Tripp-lite SRCABLETRAY User Manual download pdf (Page 3)

3 – SRCABLETRAY Installation

Note: You can remove the roof panel to aid installation, but this step is not required.

Assemble the cable tray by attaching the support sections

the trough section

with the included screws. Note: The support

sections should be attached inside the ﬂ anges of the trough

section, not outside.

Insert the tabs

at one side of the cable tray into the matching

roof panel slots

. (Several sets of slots are compatible, allowing

you to adjust the cable tray’s position to match your preference.)

Compress the unattached cable tray support section

until you

can insert the remaining tabs

into the matching roof panel

slots

. When you release pressure from the cable tray support

sections, they will expand to provide a secure ﬁ t.

Use the included hex nut

and lock washers

to connect one

end of the included ground cable

to a grounding post

the corner of the cable tray. Connect the other end of the ground

cable to the metal frame of the rack enclosure. (Follow the ground

wires connected to the rack enclosure’s doors to locate several

convenient ground connection points on the frame.)

3 4

4 – SRCABLETRAYEXP Installation

Note: You must install SRCABLETRAY before installing SRCABLETRAYEXP. SRCABLETRAYEXP includes two expansion sections; you may

install one or both, depending on your needs.

4-1 One Expansion Section

Attach the expansion section

to the cable tray

with the

included screws.

1 2 3 4

No comments

Tripp-lite SRCABLETRAY User Manual Page 3