Tripp Lite PowerVerter Owner's Manual download pdf (Page 7)

Configuration

(continued)

SetBatteryChargeConserver(LoadSense)Control—OPTIONAL

In order to save battery power, the unit's inverter automatically shuts off in the absence of any power demand from

connected equipment or appliances (the electrical load). When the Inverter/Charger detects a load, it automatically turns its



Conserver Control (see diagram). Using a small tool, turn the control clockwise to lower the minimum load that will be

detected, causing the inverter to turn on for smaller loads. When the control is turned fully clockwise, the inverter will

operate even when there is no load. Turn the control counterclockwise to increase the minimum load that will be

detected, causing the inverter to stay off until the new minimum load is reached.

NOTE: The factory setting for the control is fully clockwise. However, based on the threshold load to which you’d like the inverter to respond, you should adjust the control counterclockwise to reduce

its sensitivity until the inverter is active only when connected equipment or appliances are actually in use.

ConnectRemoteControl—OPTIONAL



separately). The remote module allows the Inverter/Charger to be mounted in a compartment or cabinet out of sight, while operated

conveniently from a remote location. See instructions packed with the remote control module.

LOAD

SENSE

MAX OFF

LOAD

SENSE

MAX OFF

Connect Battery Temperature Sensing Cable—OPTIONAL (Contact Tripp Lite for optional temperature sensing cable

accessory.)











or cold. If the sensor cable is not used, the Inverter/Charger will charge according to its default value



ConnectAutomaticGeneratorStarter—OPTIONAL

             



            

generator on when connected battery voltage levels are low and switch it off when

battery voltage levels are high.

Pin Configuration

2 - Common

3 - N.C.

(Normally Closed)

4 - N.O.

(Normally Open)

Select Battery Type - REQUIRED

Battery Type Switch Position

AGM/Gel Cell (Sealed) Battery Up

Wet Cell (Vented) Battery Down (factory setting)

CAUTION: The Battery Type DIP Switch setting must match the type of

batteries you connect, or your batteries may be degraded or damaged

over an extended period of time. See “Battery Selection,” for more

information.

9 10 11 12

AGM/

Gel Cell

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Comments to this Manuals

No comments

Tripp Lite PowerVerter Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Power adapters & inverters Tripp Lite PowerVerter