Tripp-lite BP240V10RT3U User Manual download pdf (Page 3)

Mounting

Single Unit Installation

Connect the two segments of each shelf (A) using the included screws and nuts (B).

Leave the screws slightly loose so that the shelves can be adjusted in the next step.

Adjust each shelf to fit your rack, then mount them in the lowest available space of

your rack with the screws, nuts and washers provided (C). Note that the support ledges

should face inward. Tighten the screws that connect the shelf segments (B).

Attach mounting ears (D) to the front mounting holes of your equipment (E) using the

screws provided (F). The ears should face forward.

Using an assistant if necessary, lift yourequipment and slide it onto the mounting

shelves. Attach your equipment to the rack by passing the screws, nuts and washers

provided (G) through its mounting ears andinto the rack rails.

Your equipment may be rackmounted in 4-post rack enclosures using the included rack shelves and the following suggested mounting

procedures, which should be used instead of the procedures described in your Owner's Manual (if any). These procedures are for common

enclosure types and may not be appropriate for all rack enclosures. You must determine the fitness of rackmount hardware and procedures

before mounting. If this hardware or these procedures are not suitable for your application, contact your rack enclosure's manufacturer for

a solution.

Mount one piece of equipment in a 4-post rack section using the Single Unit Installation procedure, or one piece of equipment in a 2-post

rack using the 2-Post (Telecom) Installation procedure. If you have two UPSRMRII shelf kits and a sufficiently deep rack, you may mount

two pieces of equipment in a 4-post rack section using the Back to Back Installation procedure.

1 2 3 4 5 6 7 8 ... 16 17

No comments

Tripp-lite BP240V10RT3U User Manual Page 3