Tripp-lite B064-016 User Manual download pdf (Page 20)

Firmware Upgrade

7. If the Check Firmware Version boxischecked,andtheFirmwareUpgradeUtilityndstheKVMsrmwareisnewerthan

thatofthermwareupgradele,youwillbepromptedtocontinueorcancel.Oncethermwareupgradestarts,status

messagesappearintheStatusMessagepanelandprogresstowardscompletionisshownintheProgressBar.Whenthe

upgradeiscomplete,theStatusMessagepanelwillinformyouthatthermwareupgradewasok.Atthispoint,click Finish

tocompletethermwareupgrade.Afterasuccessfulrmwareupgrade,theswitchwillresetitself.

Firmware Upgrade Failed

Intheeventofanupgradefailure,theStatus Messagespanelwilldisplayamessagethatsaystheupgradefailed,andadialog

boxwillappearaskingifyouwishtoretrythermwareupgrade.ClickYestoretrythermwareupgrade,orNo to cancel and

proceedtoarmwareupgraderecovery.

Firmware Upgrade Recovery

IfyouareunabletosuccessfullyupgradeyourKVMandSIUrmware,youmaynotbeabletooperatetheKVMswitch.Ifthis

isthecase,followtheprocedurebelowtorecoverfromarmwareupgradefailure.

KVM Firmware Upgrade Recovery

1. SlidethermwareupgraderecoveryswitchonthefrontpaneloftheunittotheRecover position.

2. Power-OFFandrestarttheKVMswitchaccordingtothePoweringOffandRestartingsectiononpage8.

3. ConnecttheincludedrmwareupgradecablefromtheRJ11rmwareupgradeportonthefrontoftheswitchtoaDB9

Serialportonthecomputeryousavedthermwareto.Note: In a daisy-chain installation, connect the ﬁrmware upgrade

cable to the Station 1 KVM. The remaining KVMs will receive the ﬁrmware upgrade via the daisy-chain cables.

4. Invoke Firmware Upgrade ModeviatheFirmwareUpgradesettinginthe F4:ADM menu.(Seepage17fordetails.)

5. Proceedwiththermwareupgradestartingwithstep4intheFirmwareUpgradeUtilitysection.(Seepage19fordetails.)

6. WhentheupgradeiscompleteandtheKVMresetsitself,power-OFFtheKVMswitch.

7. SlidethermwareupgraderecoveryswitchonthefrontpaneloftheunittotheNormalposition.Power-ONtheKVMswitch

according to the Powering Off and Restarting section on page 8.

1 2 ... 15 16 17 18 19 20 21 22 23 24

No comments

Tripp-lite B064-016 User Manual Page 20