Tripp Lite RELAYIOCARD Owner's Manual download pdf (Page 4)

2.4 AS400 Configuration

1. Press Enter to open the main menu of the RELAYIOCARD.

Press 1 to configure the alarm event for R1~R6.

2. Select the On Bypass, Low Battery, On Standby and Power Fail for R1~R4.

3. Press 0 to return to the main menu.

Then press 3 to configure the normally open or normally closed.

Select 3 to switch from Normal Open to Normal Closed

for Relay 3 (On Standby Event).

5. Set the dip switch SW2 to the ON position for the RELAYIOCARD to begin using the custom settings for the AS400 connection.

4. Press 0 to return to the main menu.

Press 0 to quit the configuration.

When the “Save Before Exit?” prompt appears,

select Y to save the configuration.

6. Connect the RELAYIOCARD terminals to the

AS400 DB9 connector as follows:

2. Installation and Setup (continued)

+---------------------------+

| UPS Relay Card |

+---------------------------+

Firmware Version: Relay Card V1.9

[1].Customize Output Relay

[2].Configure Input Signal

[3] Customize Normal Open or Normal Close

[0].Quit

Please Enter Your Choice =>

[4] Reset to Default

+---------------------------+

| Cus tomize O utput Rela y |

+-------- --------- ----------+

Relay S elected Event

[1].Relay1: O n Bypa ss

[2].Relay2: L ow Batt ery

[3].Relay3: O n Standby

[4].Relay4: Power Fail

[5].Relay5: O verload

[6] Relay6: UPS Disconnect

[0].Back To Previous Menu

Plea se Enter Your C hoice =>

+---------------------------+

| Customize Output Relay |

+---------------------------+

Relay Selected Event

[1].Relay1: Normal Open

[2].Relay2: Normal Open

[3].Relay3: Normal Close

[4].Relay4: Normal Open

[5].Relay5: Normal Open

[6].Relay6: Normal Open

[0].Back To Previous Menu

Please Enter Your Choice =>

+---------------------------+

| UPS Relay Card |

+---------------------------+

Firmware Version: Relay Card V1.9

[1].Customize Output Relay

[2].Configure Input Signal

[3] Customize Normal Open or Normal Close

[0].Quit

Please Enter Your Choice => 0

Save Before Exit? [Y]es. [N]o : Y

Data Saved.

[4] Reset to Default

201011142 932815.indb 4 1/6/2011 9:15:40 AM

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Tripp Lite RELAYIOCARD Owner's Manual Page 4

Comments to this Manuals