4
2
1
4
5
3
UPS Power Module
Battery Module
UPS Power Module
Battery Module
Transformer
D
F
E
G
C
C
B
A
B
A
C
C
B
Horizontal Rack Mounting
Note: Use the following mounting instructions with standard
rack enclosures and 4-post open frame racks only. Due to the
weight of the transformer, it must only be placed/mounted in
the lower portion of the rack.
1
It is important to note that in order to accommodate paralleling
applications, equipment must be mounted in order of weight,
starting at the bottom with the heaviest item rst, in the
following order (see diagram): Transformer, Battery Modules,
UPS Power Modules. Note: The power modules, battery
modules and transformer must be installed on separate and
individual sets of rack shelves, which are included with each
module.
2
The included plastic pegs
A
will temporarily support the
empty rackmount shelves
B
while you install the permanent
mounting hardware. Insert a peg near the center of the front
and rear bracket of each shelf as shown. (Each front bracket
has 6 holes.) The pegs will snap into place.
After installing the pegs, expand each shelf to match the depth
of your rack rails. The pegs will t through the square holes
in the rack rails to support the shelves. Refer to the rack unit
labels to conrm that the shelves are level in all directions.
Note: The support ledge of each shelf must face inward.
3
Secure the shelves
B
to the mounting rails permanently using
the included screws and cup washers
C
as shown.
• For 2U equipment mounting, place 4 screws total at the
front and 4 screws total at the back.
• For 3U equipment mounting, place 6 screws total at the
front and 4 screws total at the back.
• For 4U equipment mounting, place 6 screws total at the
front and 6 screws total at the back.
Tighten all screws before proceeding.
Warning: Do not attempt to install your equipment until
you have inserted and tightened the required screws.
The plastic pegs will not support the weight of your
equipment.
4
Attach mounting ears
D
to the front mounting holes of your
equipment
E
using the screws provided
F
. The ears should
face forward.
5
Using an assistant, lift your equipment and slide it onto the
mounting shelves. Attach your equipment to the rack by
passing the screws, nuts and washers (user-provided)
G
through its mounting ears and into the rack rails.
Comments to this Manuals