Tripp Lite IB8RM Owner's Manual download pdf (Page 2)

Phone Line Installation

(Isotel

& Isotel

Ultra Models Only)

Connect a phone cord directly from

the telephone jack to the "IN" jack of

your surge suppressor.

Your surge suppressor must be the first item in line from the

telephone jack for it to protect against surges on the phone line.

Your surge suppressor can only protect against phone line

surges if its power cord is correctly connected to a grounded,

3-wire AC outlet. It is not intended for use with network data lines.

Connect a phone cord from the device to be protected

to the "OUT" jack of your surge suppressor.

Select models protect TWO lines on one cable simultaneously (see specs.) If you have one of these

models and want to protect two lines that do NOT travel through one cable, you must use "Y"

splitters appropriate to your application to adapt them to your surge suppressor.

Troubleshooting

PROBLEM

Your circuit breaker trips.

Your Isobar is overloaded.

The green "Protection Present" and/

or "Line OK" LED(s) do not light.

Your equipment is not fully protected

against surges or there is a wiring

fault in your wall outlet.

The red "Fault" LED lights when you

first plug in your Isobar.

There is a wiring fault in your wall

outlet. (Phases are reversed, ground

is missing, etc.)

The red "Fault" LED lights after

continued use of your Isobar.

Your Isobar may have been damaged

by a surge.

Equipment plugged into the Isobar

exhibits audio static or video "snow".

Some equipment may be generating

electrical interference.

SOLUTION

Unplug some equipment. Wait one minute

while your Isobar cools, then push the

circuit breaker button back in. (See Fig. 1)

Make sure that power is available at the

wall outlet, the power switch is on and lit,

and the Isobar is completely plugged in.

Have a qualified electrician fix the fault

immediately. NOTE: A loose wall outlet may

cause the "FAULT" LED to light. Your Isobar

will identify most wiring faults, but may not

identify every possible type of fault.

Have a qualified electrician examine your

outlet to determine if a fault has developed.

If no fault exists, contact Tripp Lite for

service.

Plug your equipment into outlets not directly

across from each other (see Fig. 2,) and

plug equipment with heavy power draws

(such as printers) into outlets away from

monitors and AV equipment.

Fig. 1 Fig. 2

1 2 3 4 5 6 7 ... 11 12

Comments to this Manuals

No comments

Tripp Lite IB8RM Owner's Manual Page 2

Comments to this Manuals

Related products and manuals for Surge protectors Tripp Lite IB8RM