Tripp-lite BP240V10RT3U User Manual download pdf (Page 10)

Hardwire your isolation transformer’s UPS connector to

your UPS’s input and output.

Remove the tops of the boxes covering the UPS’s and transformer’s input and output

terminals. Pass the free end of the isolation transformer’s UPS connector through

the UPS’s cover box’s knockout, then connect it to the UPS’s input and output

terminals according to the labels on the wires and the terminals. Replace the top of

the box covering the UPS’s input and output terminals.

Hardwire your equipment to your isolation transformer’s

equipment output.

Pass your equipment’s power cable(s) through one of the transformer cover box’s

left knockouts, then connect them to the transformer’s equipment output terminals.

See the Output Voltage Diagram to determine which terminal connections will provide

which voltages.

Select your input voltage. Hardwire your isolation

transformer’s utility input to your utility power source.

Place a jumper between the 208V or 240V voltage select terminals to set the transformer’s

input voltage. Connect one end of a power cable to your utility power source. Pass

the cable’s other end through one of the transformer cover box’s center knockouts,

then connect the cable to the utility input terminals. Replace the top of the transformer

cover box.

Continue with Installation—All Applications (pg. 10)

Connection

continued

120V

240V

120V

208V

AC OUTPUT VOLTAGE DIAGRAM

Installation—With Isolation Transformer

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Tripp-lite BP240V10RT3U User Manual Page 10