Tripp-lite OMNIVSINT800 User Manual download pdf (Page 5)

“ON/OFF/STANDBY” Button

• To turn the UPS ON: if utility power is present, the UPS will turn

ON automatically. If utility power is absent, you can “cold-start” the

UPS (i.e.: turn it ON and supply power from its batteries*) by pressing

and holding the ON/OFF/STANDBY button for one second.**

• To turn the UPS OFF: first, unplug the UPS from the wall outlet;

then press and hold the ON/OFF/STANDBY button for one

second.** The UPS will be completely “OFF” (deactivated).

• To place the UPS in “Charge-Only” Mode: this mode enables battery

charging, but disables battery backup. WARNING: when the UPS is in

this mode, it will not provide battery backup during a blackout or

brownout. This mode is only recommended for use in areas that

experience frequent blackout/brownout conditions and when connected

equipment is not in use. Press and hold the ON/OFF/STANDBY

button for four seconds to place the UPS in this mode.** Press and

hold the ON/OFF/STANDBY button for one second** to take the

UPS out of this mode.

*If fully charged. **The alarm will beep once briefly after one second has passed (and

will beep continuously after four seconds have passed which signals transition to the

“Charge-Only” Mode).

“MUTE/TEST” Button

To Silence (or “Mute”) UPS Alarms: briefly press and release the

MUTE/TEST button. Note: continuous alarms (warning you to imme-

diately shut down connected equipment) cannot be silenced.

To Run a Self-Test: with your UPS plugged in and turned ON, press

and hold the MUTE/TEST button for two seconds. Continue holding

the button until the alarm beeps several times and the UPS performs

a self-test. See “Results of a Self-Test” below. Note: you can leave

connected equipment on during a self-test. Your UPS, however, will

not perform a self-test if you have placed it in “Charge-Only” mode

(see “ON/OFF/STANDBY” Button description).

CAUTION! Do not unplug your UPS to test its batteries. This will

remove safe electrical grounding and may introduce a damaging

surge into your network connections.

Results of a Self-Test: The test will last approximately 10 seconds

as the UPS switches to battery to test its load capacity and

charge.

• If the “OVERLOAD” LED remains lit and the alarm continues to

sound after the test, the battery-supported outlets are overloaded.

To clear the overload, unplug some of your equipment from the bat-

tery- supported outlets and run the self-test repeatedly until the “OVER-

LOAD” LED is no longer lit and the alarm is no longer sounding.

CAUTION! Any overload that is not corrected by the user

immediately following a self-test may cause the UPS to shut

down and cease supplying output power in the event of a

blackout or brownout.

• If the “REPLACE BATTERY” LED remains lit and the alarm

continues to sound after the test, the UPS batteries need to be

recharged or replaced. Allow the UPS to recharge continuously

for 2-4 hours, and repeat the self-test. If the LED continues to

flash, contact Tripp Lite for service. If your UPS requires battery

replacement, visit www.tripplite.com to locate the specific

Tripp Lite replacement battery for your UPS.

Basic Operation

Buttons

200404081 932242 OmniVSINT800_1000_ 1500XL Owners Manual .qxd 6/8/2004 11:36 AM Page 5

1 2 3 4 5 6 7 8 9 10 ... 31 32

Comments to this Manuals

No comments

Tripp-lite OMNIVSINT800 User Manual Page 5

Comments to this Manuals

Related products and manuals for Tools Tripp-lite OMNIVSINT800