Tripp Lite OMNIVS800 User Manual download pdf (Page 6)

All Indicator Light descriptions apply when the UPS is plugged into an AC outlet and turned on.

AC Outlets: the

outlets will provide battery backup and surge

protection; plug your computer, monitor and other critical devices here.

The

outlets will provide surge protection only; plug your printer and

other non-essential devices here. Your UPS is designed to only support

computer equipment. You will overload the UPS if the total VA ratings for

all the equipment you connect to the

outlets exceeds the UPS’s Output

Capacity (see Specifications). If you are unsure if you have overloaded the

outlets, run a self-test (see “MUTE/TEST” Button description).

Basic Operation continued

Other UPS Features

Indicator Lights

“LINE POWER” LED: this green LED lights continuously to indicate

that the UPS is ON and supplying your equipment with AC power from a

utility source. The LED flashes to remind you that you have used the ON/

OFF button to place the UPS in “Charge-Only” mode.

“BATTERY POWER” LED: this yellow LED flashes and an alarm

sounds (4 short beeps followed by a pause) to indicate the UPS is operating

from its internal batteries. During a prolonged brownout or blackout, this

LED and the “REPLACE BATTERY” LED will light continuously and an

alarm will sound continuously to indicate the UPS's batteries are nearly out

of power; you should save files and shut down your equipment

immediately.

“REPLACE BATTERY” LED: this red LED lights continuously and an

alarm sounds after a self-test to indicate the UPS batteries need to be

recharged or replaced. Allow the UPS to recharge continuously for 12

hours, and repeat the self-test. If the LED continues to flash, contact Tripp

Lite for service. If your UPS requires battery replacement, visit www.

tripplite.com/support/battery/index.cfm to locate the specific Tripp Lite

replacement battery for your UPS.

“OVERLOAD” LED: this red LED lights continuously and an alarm

sounds after a self-test to indicate the battery-supported outlets are

overloaded. To clear the overload, unplug some of your equipment from the

battery-supported outlets and run the self-test repeatedly until the LED is

no longer lit and the alarm is no longer sounding.

CAUTION! Any overload that is not corrected by the user immediately

following a self-test may cause the UPS to shut down and cease

supplying output power in the event of a blackout or brownout.

“VOLTAGE CORRECTION” LED (select models only): Lights green

whenever your UPS is automatically correcting high or low AC line

voltage. The UPS will also click gently. These are normal, automatic

operations of your UPS, and no action is required on your part.

NORM DELAY

OMNIVS1500XL shown

NORM DELAY

OMNIVS1000 shown

NORM DELAY

OMNIVS800 shown

200912037 93-2248.indd 6 12/17/2009 11:06:01 AM

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

Tripp Lite OMNIVS800 User Manual Page 6

Comments to this Manuals

Related products and manuals for Uninterruptible power supplies (UPSs) Tripp Lite OMNIVS800