Tripp Lite SMARTINT1500 Owner's Manual download pdf (Page 6)

Specifications

Storage & Service

Storage

Turn your UPS OFF: first engage the ON/Standby Switch and release it to place

your UPS in the “Standby” mode, then disconnect the UPS power cord from the

wall outlet. If you plan on storing your UPS for an extended period of time,

recharge the UPS batteries once every three months. Follow steps #1 and #3

in the Quick Installation section and allow the UPS to charge from 4 to 6 hours.

If you leave your UPS batteries discharged for an extended period of time, they

will suffer permanent loss of capacity.

Service

If returning your UPS for service, contact your local Tripp Lite dealer or

distributor. They will refer you to a service center. Please carefully pack the UPS

using the ORIGINAL PACKING MATERIAL that came with the unit. Enclose a

letter describing the symptoms of the problem. If the UPS is within the 2 year

warranty period, enclose a copy of your sales receipt.

Smart INT 450 Smart INT 700 Smart INT 1000

Output Capacity (VA/Watts): 450/280 700/425 1000/680

Battery Runtime (Half Load/

Full Load) Minutes: 19/5 20/6 23/8

Battery Recharge Time: 2-4 hrs. 2-4 hrs. 2-4 hrs.

Approvals: UL, CE UL, CE UL, CE

Smart INT 1500

Output Capacity (VA/Watts): 1500/940

Battery Runtime (Half Load/

Full Load) Minutes: 25/10

Battery Recharge Time: 2-4 hrs.

Approvals: UL, CE

Input Voltage (230V); Input Frequency (50/60 Hz, Auto-Selecting); On-Line Input Voltage Range (151-274 volts); Voltage-Regulated Output

Voltage Range (230V +6%/-15%); On-Battery Output Voltage Range (230V ± 5%); Output Waveform Line Mode (filtered sinewave); Output

Waveform Battery Mode (PWM sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards);

AC Noise Attenuation (>40 dB); AC TVSS Protection Modes (H to N, H to G, N to G).

The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change.

External Battery Connector (Select Models Only)

Use to connect additional Tripp Lite battery packs for additional

runtime. Refer to the label next to the connector for the appro-

priate Tripp Lite battery pack to connect. Refer to instructions

available with the battery pack for complete connection informa-

tion and safety warnings.

Battery Replacement Door

Under normal conditions, the original battery in your UPS will last

several years. Battery replacement should be performed only by

qualified service personnel. Refer to “Battery Warnings” in the

Safety section on page 2.

200311039 93-xxxx SmartINT1500 Owner's Manual_English.p65 11/25/2003, 11:56 AM6

1 2 3 4 5 6 7 8 9 10 11 ... 26 27

Comments to this Manuals

No comments

Tripp Lite SMARTINT1500 Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for Uninterruptible power supplies (UPSs) Tripp Lite SMARTINT1500