Tripp Lite SU8000RT3UG Owner's Manual download pdf (Page 3)

Mounting (Rack)

4-Post Mounting

The included plastic pegs

will temporarily support the empty rackmount shelves

while

you install the permanent mounting hardware. Insert a peg near the center of the front and rear

bracket of each shelf as shown. (Each front bracket has 6 holes and each rear bracket has 3 holes.)

The pegs will snap into place.

After installing the pegs, expand each shelf to match the depth of your rack rails. The pegs will

fit through the square holes in the rack rails to support the shelves. Refer to the rack unit labels to

confirm that the shelves are level in all directions. Note: The support ledge of each shelf must

face inward.

Secure the shelves

to the mounting rails permanently using the included screws and cup

washers

as shown.

• For 2U equipment mounting, place 4 screws total at the front and 4 screws total at the back.

• For 3U equipment mounting, place 6 screws total at the front and 4 screws total at the back.

Tighten all screws before proceeding.

Warning: Do not attempt to install your equipment until you have inserted and tightened

the required screws. The plastic pegs will not support the weight of your equipment.

Attach mounting ears

to the front mounting holes of your equipment

using the screws

provided

. The ears should face forward.

Using an assistant, lift your equipment and slide it onto the mounting shelves. Attach your

equipment to the rack by passing the screws, nuts and washers (user-provided)

through its

mounting ears and into the rack rails.

(Optional) Attach 2 PDU hanger brackets to the right-side, rear mounting rail using included

screws and cage nuts. Important: determining where to attach your PDU hanger brackets will

depend on your rack configuration. Generally it is recommended to mount the top bracket in

the bottom two square holes of the U space that the UPS and PDU are mounted in. The second

bracket should be installed 3U measures down and placed in the top two square holes of the U.

(For example: If the PDU and UPS are mounted in 7U, the first bracket will be installed in the

bottom two square holes of 7U. The second bracket would be installed in the top two square holes

of 4U.

Mount your equipment in either a 4-post or 2-post rack or rack enclosure. The user must determine the fitness of hardware and procedures before

mounting. If hardware and procedures are not suitable for your application, contact the manufacturer of your rack or rack enclosure. The procedures

described in this manual are for common rack and rack enclosure types and may not be appropriate for all applications.

Note: The power module and battery module must be installed in separate shelves.

2-Post Mounting (Optional)

To mount your equipment in a 2-post rack, you must purchase a Tripp Lite 2-Post Rackmount Installation Kit (model: 2POSTRMKITWM, sold

separately) for each module installed. See the Installation Kit’s owner’s manual for complete mounting instructions.

Mount Here

201102160 93-2897.indb 3 3/30/2011 9:30:39 AM

1 2 3 4 5 6 7 8 ... 103 104

Comments to this Manuals

No comments

Tripp Lite SU8000RT3UG Owner's Manual Page 3

Comments to this Manuals

Related products and manuals for Uninterruptible power supplies (UPSs) Tripp Lite SU8000RT3UG