Tripp Lite SU750RTXLCD2U Owner's Manual download pdf (Page 5)

Installation

4-Post Mounting (2U Units)

The included plastic pegs

will temporarily support the empty

rackmount shelves

while you install the permanent

mounting hardware. Insert a peg into the third hole from the

top on the front end of each bracket. On the rear end, insert a

peg into the center hole. (Each front bracket has 6 holes and

each rear bracket has 5 holes.) The pegs will snap into place.

After installing the pegs, expand each shelf to match the depth

of your rack rails. The pegs will fit through the square holes in

the rack rails to support the shelves. Refer to the rack unit

labels to confirm that the shelves are level in all directions.

Note: The support ledge of each shelf must face inward.

Remove the pegs at the front end of each bracket. Secure the

shelves

to the mounting rails permanently using the

included screws and cup washers

as shown. Place 2 screws

at the front of each rail (4 total) and 2 screws at the back of

each rail (4 total). Tighten all screws before proceeding. Note:

The rear pegs can be left in for installation, but the front ones

must be removed before the bracket is secured by screws.

WARNING!

Do not attempt to install your UPS until you have

inserted and tightened the required screws. The plastic

pegs will not support the weight of your UPS.

Attach your UPS’s mounting brackets

to the forward

mounting holes

of the UPS using the included hardware

The mounting bracket “ears” should face forward.

With the aid of an assistant (if necessary), lift your UPS and

slide it into the shelves. Attach the UPS mounting brackets to

the forward mounting rails with user-supplied screws and

washers

. Tighten all screws securely.

13-11-176-93-3156.indb 5 11/27/2013 4:24:39 PM

1 2 3 4 5 6 7 8 9 10 ... 91 92

No comments

Tripp Lite SU750RTXLCD2U Owner's Manual Page 5