Tripp Lite APSX2012SW User Manual download pdf (Page 11)

4. Installation and Operation

4.3 Installation and Start-Up

4.3.1

Connect the unit to the batteries per Section 3. Ensure that the nominal DC battery voltage is 12V.

4.3.2

Connect the unit to the AC load. Then connect to the AC source. Conrm that all wiring is correct and terminal is tight.

4.3.3

Press the ON/OFF button. The system will start working after a few seconds. If the AC source power fails, the unit will work in

Inverter mode. Otherwise, the system will switch to AC Mode and will power the load while charging the battery.

5. Technical Speciﬁcations

Model

Speciﬁcation

APSX1012SW APSX2012SW

Continuous Power 1000 Watts 2000 Watts

Peak Inverter Efciency >82%

Output Waveform Sine Wave

DC Current at Rated Power 120 Amps 240 Amps

Recommended Battery Fuse 200 Amps 400 Amps

Nominal Input Voltage 12 VDC

DC Input Voltage Range 10.0 ~ 16 VDC

Low Battery Protection (Heavy/Light Load) 10.9/11.2 VDC

DC Mode Output Voltage Regulation +/- 10%

Power Factor Allowed 0.8 to 1

Frequency Regulation 50/60 Hz, +/- 0.5 Hz (Autoselect)

Standard Output Voltage 230 VAC

Load Sensing (Power Saving) 100W

Transfer Time 16 ms max

Forced Air Cooling Variable Speed

Automatic Transfer Relay 15A 30A

Adjustable Charge current 4 ~ 40 A 6 ~ 60 A

Resistive Load 100%

Inductive Load YES

Motor Load YES

Rectier Load YES

Wall-Mounting YES

201110117 93-3054.indb 11 11/9/2011 10:57:58 AM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

No comments

Tripp Lite APSX2012SW User Manual Page 11