For earlier version Windows computers
follow the steps in Section B,
connection over the COM port using
Connect directly to another computer
Set up an advanced connection
Serial Port that is connected to the
Windows computer COM port:
(for the particular Serial Port
that is connected to the Windows computer COM port)
(which will enable port forwarding and SSH
his will override all other Configuration protocols on that port
fields blank, they default to
where XX is the serial port number. So the default userna
me and password for Secure RDP over
(Baud Rate, Flow Control) are the same as were set
up on the Windows computer COM port and click
RDP and VNC forwarding over serial ports is enabled on
a Port basis. You can add Users who can
have access to these ports (or reconfigure User profiles) by selecting
as described earlier in Chapter 4
software running on your remote computer
specify the gateway IP address of
and a username/password for a
user you have setup on the
Comments to this Manuals