also be used to access text consoles on devices that are attached to the
serial ports. For these connections, you must configure the
Service that will access the target gatewayserial port, and then set
the gateway up as a host:
client as the Client. Enter 2002 in
Assuming you have already set up the target
host. Alternatively, select
enter something along the lines of Loopback ports, or Localserial ports. Click
access to the serial console
on the device attached to serial
to access to devices connected to the gateway’s serial ports, you
itself to allow port forwarded network access to itself, and enable
to the nominated serial port:
to selected Port # (e.g. Port 2 if the target device is attached to the second serial port)
the port's serial configuration
is appropriate for the attached device
and scroll to the bottom and click
loopback address) and enter
revious step, so for Port 2 you would enter
Comments to this Manuals