Receive DSR/DCD/CTS changes
if the flow control signal status from the physical serial
is to be reflected back to the Windows COM port driver (as some se
communications applications prefer to run without any hardware flow control
Propagate local port changes
rial device control by the Windo
application so it operates exactly like a directly connected
serial COM port. It provides a
complete COM port interface between the attached serial device and the network, providing
hardware and software flow control. So the baud rate
of the remote serial port is
controlled by the settings for that COM port on
Windows computer. If not selected then the
port serial configuration parameters are seton the
will only send data out at the baud rate
configured by the local Application using the COMpor
At any stage you can delete a single configuredCOM port, or delete the
all the COM ports configured on that
Select the console server or C
port on the left hand menu a
Configure the Remote Serial Device C
Ensure the remote serial device is connected to your remote
. Then configure the serial
port as detailed in the User Guide
Set the RS232 Common Settings (e.g.
mode and specify the appropriate protocol to be used:
allows connections directly to a TCP socket and thedefault TCP port
address is 4000 + serial port # (
the address of the second serial port is
enables serial port redirection on that port and thedefault port address is
IP Address Port (5000 + serial port #)
mode enables encrypted communication
Comments to this Manuals