You would need to issue the following commands from the command line:
set=config.interfaces.wan.mode=static
set=config.interfaces.wan.address=192.168.1.100
set=config.interfaces.wan.netmask=255.255.255.0
set=config.interfaces.wan.gateway=192.168.1.1
set=config.interfaces.wan.dns1=192.168.1.254
set=config.interfaces.wan.dns2=10.1.0.254
following command will synchronize the live sy
stem with the new configuration:
in access on the DB9 serial port from the command line with the following
Serial Port Flow Control:
You would need to issue the following commands from the command line to set system
set=config.console.ppp.localip=172.24.1.1
set=config.console.ppp.remoteip=172.24.1.2
set=config.console.ppp.auth=MSCHAPv2
set=config.console.ppp.enabled=on
set=config.console.speed=115200
Comments to this Manuals