If you wish to set the same protocol options for
multiple serial ports at once
ou wish to configure as a group.
configured the common settings and the mode for each port, set up any remote
has been configured with distributed Nagios monitoring enabled then
will also be presented with
options to enable nominated services on the Host to
There are a number of common settings
. These are independent of the
which the port is being used. T
Specify a label for the port
(and ensure they match the
for serial device that is connected)
The Signaling Protocol is
hard configured to be RS232
are all set at the factory to RS232 9600 baud, no parity, 8 data bits, 1 stop
baud rate can be changed to 2400
management console. Lower baud rates (50
can be configured from the command line
Comments to this Manuals