Tripp Lite B092-016 Owner's Manual download pdf (Page 176)

176

14.5.2

Supported Protocol Configuration

To en

sure re

mote access to serial port 5 is

configured as follows:

Telnet

Access LAN

Disabled

SSH Access LAN

Enabled

Raw TCP

via

LAN

Disabled

You would need to issue the following commands from the command line to set system

configuration:

# /bin/config

–

t=config.ports.port5.ssh=on

# /bin/config

–

del=config.ports.port5.

Telnet

# /bin/config

–

del=config.ports.port5.tcp

The following command will synchronize the live sy

stem with the new configuration:

# /bin/config

–

run=serialconfig

Note: “/bin/config” co

mmands can be combined into one command for convenience.

14.5.3

Users

You can add a U

ser to the system from the command line by

performing

the following

instructions:

Determine the total number of existing

Users

. I

f you have no existing User

you can as

sume

this is 0.

# /bin/config

–

get=config.users.total

This command should display:

config.users.total 1

Note that if you see:

config.users.total

This means you have 0 U

sers configured.

So your new U

ser will be the existing total plus 1

so if the previous

command gave you 0

then

you start with user number 1. I

f you already have 1 user

your new user will be number 2

etc.

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 241 242

Comments to this Manuals

No comments

Tripp Lite B092-016 Owner's Manual Page 176

Comments to this Manuals

Related products and manuals for KVM switches Tripp Lite B092-016